1, Proposed start and operate right
Like the car number, the owner of the scooter also always had this habit. However, as for the scooter, this habit has “devastated” to be much larger. Usually, the scooters are always higher than the machine forward round models. So at the time of launch, if not explosive approach galanti, the original standby splenic noise or even “fence” emanating from the engine’s supap system makes car owners have to spend quite a large amount of money to make the car explode smoothly back back.
2, front brakes abuse
With the right-handed habits, many car owners are familiar do squeeze the brakes prior to being startled. The front brakes use with airport terminal going to a lot of dangers due to the diameter of the rim of a small car, cruise absorbers. Please always use the two simultaneously braking and to ensure the most secure. On a number of new, railway station, the vehicles brakes at the same time CBS always allows users to just use a brake left is can stop using both brakes.
3, airport terminal as go … vehicle No.
Make the “tufa wugu station” for the fast growth of the car and then folding brake clutch con clusters will render and you wire transmission belts fast is broken. Also, when done type “ga” tufa lilugu and continuous brakes also means you are “throwing” the Cup “” his gasoline each go in vain.
When tufa lilugu throttle, the car gives you a great acceleration and strength to be able to move. But when squeeze brake folding, the sudden deceleration of the car you will have to continue to “load” the corresponding gasoline amounts to go forward. Please always keep the speed and hand are all possible, this will bring back the durability for clutches, belts and crab saves more fuel.
4, Not clean gasoline
For many new scooter, cars such as the Honda Honda Sh, SCR … use the float type is designed with a petrol filter fig “leaf” take on gasoline nozzle covers. The cluster is located in immersion gas float tank of fuel.
A lot of car owners who ignore this detail when conducting maintenance as well as when in use. This makes the filter plate after a period of use will occur the phenomenon of loss of iron and hang on to the gasoline filter dirt leads to clogged suction gas, gasoline pump failure, or “gently” rather than causing the car not to achieve maximum speed and capacity due to the lack of gasoline. So please always check gasoline floats on the whole maintenance period so that the car can operate better.
5, Use the oil would also be
With the mentality “of oil would rather cheap” and “oil is oil” of many car owners will cause malfunction and engine durability. On the market today, there are many types of oil are sold with different features and uses. So, choose the correct type of oil used for airport terminal is important.
There are many ways to find the right type of oil for her car, the best way is to read carefully the type of oil use for vehicles are recorded in the manual in use when buying a new car. When replacing oil in the car, please don’t “regret” by the oil the car more expensive cars always station number. Ask digital vehicle oils ga before oil change. The most simple way, on each vehicle’s oil bottle ga always contains the words “scooter” written on the box label.
Instructions for maintenance of the scooter for you
Car maintenance good station will help you keep the car always like new, more durable and secure for you when in traffic.
1, oil change
Oil change is very important, especially with the engine cooled when as scooter. air cooled engines tend to be hotter than the water cooled engines as cars or trucks. The RPM of the motor scooter run very high, can quickly damage the oil. You should change the oil for scooters when the car was about 1,500 km. The oil should be replaced with a high quality oils are designed to withstand high temperatures, high compression engine.
In cold climates, you should use a 10W40 viscosity oil to the engine works well. In the warmer climate, 20W40 oil is often recommended.
2, brakes and strings ga
Over time, the brake cable and wire ga would be a stretch and can affect the performance and safety while riding scooters. Use oil regularly will help to make the brake cord is not strained or bound together. A few drops of machine oil or WD40 at the point of intersection between the brake line can help lubricate it.
3, bolts and bearings
Wheel bolts and bearings, as well as the other screws of your scooter you should check regularly. This is best done with each oil change, but in some cases, you should also test to make sure it is always in the best condition. You should prepare a small wrench in the trunk, to be able to check as needed.
4, maintenance of the tires and suspension
You should check the tires and pumping regular car. Don’t get too immature, tires or tire pump stretch too difficult when going back to you.
On the other hand from time to time, reduced corrosion shock parts can make no better traction tires. Worn tires and suspension parts damage can affect your safety when riding.